Shop van uitersten

Gratis verzending in Nederland bij bestellingen vanaf € 75,-.

Vision TC-HDMIWMTX AV transmitter audio/video extender

op werkdagen voor 17:00 besteld, volgende werkdag in huis

Schrijf de eerste beoordeling van dit product

Take wireless HDMI one step further; send content from your laptop to one or two flat-panel displays or projectors – even through walls – with ease. No software or drivers necessary. It is plug-and-play, and intuitive.

Channel System
Each device has a channel selector which scrolls through ten channels. Transmitters (Tx) connect to each source, and each are set to transmit on different channels. Use up to 10 x Tx in the same WiFi area since they all use different channels. Receivers (Rx) connect to the displays. To determine which source they show adjust the channel.

System Rules
As you plan your system be aware it is not possible for three or more Rx to be on the same channel.

Matrix
Two sources can be patched to two displays. Set the transmitters to different channels, then adjust the channel on each Rx to switch which source is shown.

Distribution
Show content from one laptop on two displays. Connect a Tx to the laptop, and a Rx to each display. Set them all to the same channel, and you’re done.

Switching
Supports switching up to ten sources on a display. Connect a transmitter (Tx) to each laptop, and a receiver (Rx) to each display. Change the channel on the Rx to determine which source it displays.

Present Button
Distribution

When only one display is in use, the Present button on each transmitter can be used to remotely change the channel on the receiver. Note: the switch on the rear must be set to activate this.

Blend Systems
Because there are ten channels available you can blend together matrix, distribution, and switching systems

Range
The range can be up to 30 metres (98ft) in an enclosed environment – or up to 50 metres (164ft) in an open space. Too close or too far away and the image will degrade. It uses the same frequencies as wifi so it will work through dry-walls but performance drops off with distance and physical obstacles

5GHz
It creates it’s own WiFi network in the 5GHz frequency band and uses non-DFS channels to avoid interference. The signal is made secure with 128 bit AES encryption.

Control
As well as using the buttons on the front panel to select channels, an included IR remote control directly selects channels, or a control system can switch them via RS-232.

WiFi Troubleshooting
An onscreen display can be used to look at the frequency spectrum to see what other devices might be interfering with your systems.

HDMI
Switching


It is HDMI 1.3 with HDCP 1.2 compliance. Features not supported are ARC (Audio Return Channel), and Ethernet.

Low Latency
The TC-HDMIWM has a latency of less than 200 millisecond – 1/5 of a second. It can support up to 1080P (1920 x 1080) video and is smooth and glitch-free.

IR Passthrough
Includes IR blaster and receiver cables to allow control of the source device from the remote display. Supports 20-60KHz frequencies.

Sleep
If the source is turned off or goes to sleep, the displays associated with that source will also be allowed to sleep.

Beschikbaarheid: In voorraad

€ 225,99

op werkdagen voor 17:00 besteld, volgende werkdag in huis

Gratis verzending *

14 dagen bedenktijd

Achteraf betalen

V.a. € 75,- gratis verzending

Onze vermelding op https://www.keurmerk.info

Details

Take wireless HDMI one step further; send content from your laptop to one or two flat-panel displays or projectors – even through walls – with ease. No software or drivers necessary. It is plug-and-play, and intuitive.

Channel System
Each device has a channel selector which scrolls through ten channels. Transmitters (Tx) connect to each source, and each are set to transmit on different channels. Use up to 10 x Tx in the same WiFi area since they all use different channels. Receivers (Rx) connect to the displays. To determine which source they show adjust the channel.

System Rules
As you plan your system be aware it is not possible for three or more Rx to be on the same channel.

Matrix
Two sources can be patched to two displays. Set the transmitters to different channels, then adjust the channel on each Rx to switch which source is shown.

Distribution
Show content from one laptop on two displays. Connect a Tx to the laptop, and a Rx to each display. Set them all to the same channel, and you’re done.

Switching
Supports switching up to ten sources on a display. Connect a transmitter (Tx) to each laptop, and a receiver (Rx) to each display. Change the channel on the Rx to determine which source it displays.

Present Button
Distribution

When only one display is in use, the Present button on each transmitter can be used to remotely change the channel on the receiver. Note: the switch on the rear must be set to activate this.

Blend Systems
Because there are ten channels available you can blend together matrix, distribution, and switching systems

Range
The range can be up to 30 metres (98ft) in an enclosed environment – or up to 50 metres (164ft) in an open space. Too close or too far away and the image will degrade. It uses the same frequencies as wifi so it will work through dry-walls but performance drops off with distance and physical obstacles

5GHz
It creates it’s own WiFi network in the 5GHz frequency band and uses non-DFS channels to avoid interference. The signal is made secure with 128 bit AES encryption.

Control
As well as using the buttons on the front panel to select channels, an included IR remote control directly selects channels, or a control system can switch them via RS-232.

WiFi Troubleshooting
An onscreen display can be used to look at the frequency spectrum to see what other devices might be interfering with your systems.

HDMI
Switching


It is HDMI 1.3 with HDCP 1.2 compliance. Features not supported are ARC (Audio Return Channel), and Ethernet.

Low Latency
The TC-HDMIWM has a latency of less than 200 millisecond – 1/5 of a second. It can support up to 1080P (1920 x 1080) video and is smooth and glitch-free.

IR Passthrough
Includes IR blaster and receiver cables to allow control of the source device from the remote display. Supports 20-60KHz frequencies.

Sleep
If the source is turned off or goes to sleep, the displays associated with that source will also be allowed to sleep.

Technische details

SoortAV transmitter
Maximum resolutie1920 x 1080 Pixels
ConnectiviteitstechnologieDraadloos
Maximaal bereik50 m
Maximale refresh snelheid60 Hz
AudiosysteemStereo
Ondersteunde video-modi1080p
Ondersteunde grafische resoluties1920 x 1080 (HD 1080)
Aantal1
Ondersteunde beveiligingsalgoritmen128-bit AES

Poorten & interfaces

HDMI in1
Aantal HDMI-uitgangen1
HDMI versie1.3
3,5 mm inJa
3,5 mm-uitgangJa

Eisen aan de omgeving

Temperatuur, in bedrijf0 - 40 °C
Relatieve luchtvochtigheid, in bedrijf0 - 90 procent

Energie

AC invoer voltage100 - 240
AC invoer frequentie50/60
Operating voltage5 V
Stroom2
Typisch stroomverbruik10 W
Stroomverbruik (zender) (max)5 W

Gewicht en omvang

Transmitter afmetingen (WxDxH)80 x 135 x 23 mm

Verpakking

Lengte van de verpakking13,5 cm

Extra informatie

Productcode 4432256000002
EAN 4432256000002
Merk Vision
OEM code TC-HDMIWMTX
Levertijd Op werkdagen voor 17:00 besteld, volgende werkdag in huis

Schrijf uw eigen beoordeling

U plaatst een beoordeling over: Vision TC-HDMIWMTX AV transmitter audio/video extender

Hoe waardeert u dit product? *

  1 ster 2 sterren 3 sterren 4 sterren 5 sterren
Prijs
Productbeschrijving

Details

Take wireless HDMI one step further; send content from your laptop to one or two flat-panel displays or projectors – even through walls – with ease. No software or drivers necessary. It is plug-and-play, and intuitive.

Channel System
Each device has a channel selector which scrolls through ten channels. Transmitters (Tx) connect to each source, and each are set to transmit on different channels. Use up to 10 x Tx in the same WiFi area since they all use different channels. Receivers (Rx) connect to the displays. To determine which source they show adjust the channel.

System Rules
As you plan your system be aware it is not possible for three or more Rx to be on the same channel.

Matrix
Two sources can be patched to two displays. Set the transmitters to different channels, then adjust the channel on each Rx to switch which source is shown.

Distribution
Show content from one laptop on two displays. Connect a Tx to the laptop, and a Rx to each display. Set them all to the same channel, and you’re done.

Switching
Supports switching up to ten sources on a display. Connect a transmitter (Tx) to each laptop, and a receiver (Rx) to each display. Change the channel on the Rx to determine which source it displays.

Present Button
Distribution

When only one display is in use, the Present button on each transmitter can be used to remotely change the channel on the receiver. Note: the switch on the rear must be set to activate this.

Blend Systems
Because there are ten channels available you can blend together matrix, distribution, and switching systems

Range
The range can be up to 30 metres (98ft) in an enclosed environment – or up to 50 metres (164ft) in an open space. Too close or too far away and the image will degrade. It uses the same frequencies as wifi so it will work through dry-walls but performance drops off with distance and physical obstacles

5GHz
It creates it’s own WiFi network in the 5GHz frequency band and uses non-DFS channels to avoid interference. The signal is made secure with 128 bit AES encryption.

Control
As well as using the buttons on the front panel to select channels, an included IR remote control directly selects channels, or a control system can switch them via RS-232.

WiFi Troubleshooting
An onscreen display can be used to look at the frequency spectrum to see what other devices might be interfering with your systems.

HDMI
Switching


It is HDMI 1.3 with HDCP 1.2 compliance. Features not supported are ARC (Audio Return Channel), and Ethernet.

Low Latency
The TC-HDMIWM has a latency of less than 200 millisecond – 1/5 of a second. It can support up to 1080P (1920 x 1080) video and is smooth and glitch-free.

IR Passthrough
Includes IR blaster and receiver cables to allow control of the source device from the remote display. Supports 20-60KHz frequencies.

Sleep
If the source is turned off or goes to sleep, the displays associated with that source will also be allowed to sleep.

Technische details

SoortAV transmitter
Maximum resolutie1920 x 1080 Pixels
ConnectiviteitstechnologieDraadloos
Maximaal bereik50 m
Maximale refresh snelheid60 Hz
AudiosysteemStereo
Ondersteunde video-modi1080p
Ondersteunde grafische resoluties1920 x 1080 (HD 1080)
Aantal1
Ondersteunde beveiligingsalgoritmen128-bit AES

Poorten & interfaces

HDMI in1
Aantal HDMI-uitgangen1
HDMI versie1.3
3,5 mm inJa
3,5 mm-uitgangJa

Eisen aan de omgeving

Temperatuur, in bedrijf0 - 40 °C
Relatieve luchtvochtigheid, in bedrijf0 - 90 procent

Energie

AC invoer voltage100 - 240
AC invoer frequentie50/60
Operating voltage5 V
Stroom2
Typisch stroomverbruik10 W
Stroomverbruik (zender) (max)5 W

Gewicht en omvang

Transmitter afmetingen (WxDxH)80 x 135 x 23 mm

Verpakking

Lengte van de verpakking13,5 cm
Extra informatie

Extra informatie

Productcode 4432256000002
EAN 4432256000002
Merk Vision
OEM code TC-HDMIWMTX
Levertijd Op werkdagen voor 17:00 besteld, volgende werkdag in huis
Beoordelen

Schrijf uw eigen beoordeling

U plaatst een beoordeling over: Vision TC-HDMIWMTX AV transmitter audio/video extender

Hoe waardeert u dit product? *

  1 ster 2 sterren 3 sterren 4 sterren 5 sterren
Prijs